Manual inflation test using Bluetooth button
You can manually test for an inflation and deflation to confirm the correct setup.
Turn the Pebble and Base ON, each showing a solid white light.
Press and release (do not hold) the Bluetooth button.
You will see a quick white blinking light on the Pebble and Base. The 1 minute inflation and deflation cycle will then begin. This confirms that your device is working correctly.
If you hear the pump but don't see the motion check this article to troubleshoot.
Related Articles
User Manual
You can find our User manual here.
How do I reset Smart Nora?
Using a paperclip, press the small reset button housed with the Pebble (located between the Lock switch and the Bluetooth button) and the Base Unit (located below the air nozzle).
How Do I set Up my Nora Gen 2?
To learn more about the mobile Companion App and our road map go here 1. Connect Air Tube Connect the Air Tube from the Pillow Insert into the Base. 2. Connect Base Charger Place Base Plug into Base Charger. Connect Base Charger into Base. Plug the ...
Should I turn OFF the Base Unit at any time?
We recommend always leaving your Base Unit on AND plugged in as it only has a 24 hour charge unplugged. Turning the Base Unit off can interrupt the Bluetooth connection and cause your Pebble to flash blue. Rest assured that leaving the Base Unit on ...
How do I set up Smart Nora?
Pro-tips 1. Use the 30-minute Delayed Start Smart Nora will wait 30 minutes before activating so you can fall asleep first. Press and hold ON button for 3 seconds to activate the delayed start mode. Learn More 2. Adjust the Snore detection ...